Jason Clifton
New member
I finished building my second attempt at the heatermeter project and everything is powered up and working great.
I do have one small issue though. I have a different case than the 3d printed case most are using so I had to get creative with my button mount and run wire from the button to the pcb. The button works properly except for the back button. I looked at the schematic and it looks like the back button is number two on the schematic. If i read the data sheet for the button correctly number two on the button should be the middle contact on the left side from the top. Is this correct?
I do have one small issue though. I have a different case than the 3d printed case most are using so I had to get creative with my button mount and run wire from the button to the pcb. The button works properly except for the back button. I looked at the schematic and it looks like the back button is number two on the schematic. If i read the data sheet for the button correctly number two on the button should be the middle contact on the left side from the top. Is this correct?