Burner uneven burn...SOLUTION


 

Eric Bechto9l

New member
This one has been discussed many times before, but I haven't seen my unique fix for it yet so here it goes.

The burners were uneven, and one of them at any setting below medium was completely out. Now the solution is to remove the valve assembly and blow it out with compressed air. And that works, except on mine the hose was pretty much rusted onto the valve assembly and I don't have an air compressor.

My fix was to remove the valve assembly from the grill but leave the hose attached. Then I opened up the front and rear assembly on "HIGH" and using a can of compressed air, the stuff you blow keyboards out with, I put the can nozzle up against the REAR tube hole and essentially blew out the front. Then I went to MED and LOW on the front. I then utilized the front valve on "HIGH" to blow out the other two valves, each on all three settings, one at a time.

Works like new.
 

 

Back
Top