Search results

I have been working on getting my HeaterMeter settings dialed in and have a question. When I am smoking on my large big green egg, I get the egg to the target temperature and then add the meat. If I add a lot of cold meat like a couple of pork butts, the temperature will drop and stay there...

I am testing my 4.3 HeaterMeter in a sous vide setup with a crock pot. I have my temp set to 165 F. As the water was heating up and got to about 115 the meter started continuously cycling the lid open. I initially had the lid open at 20% I have tried 99% and 6% and it keeps cycling. Why...

I put together a Ver 4.3 board and was having trouble with the fan always staying on. It turns out Q1 was pushed over and the center lead had come out of the base. See post https://tvwbb.com/showthread.php?68203-Fan-Won-t-Shut-Off. I replaced Q1 and the fan was working properly. I put the...

What do I need to make my settings so the fan never comes on and the HeaterMeter only works in servo mode? I want to unhook my fan and the heatermeter software to only operate in servo mode and not try to make temp adjustments with the fan. Bob

I put together a Ver 4.3 board. I also have a microdamper. On my first cook everything worked great. The temp went to my set temperature and leveled off within a couple of degrees. It then stayed within 5-10 degrees the whole 6 hours of the cook. Earlier today, I was working on my second cook...

I'm somewhat new to soldering and have tried a few times in the past and am terrible at it. When putting together the HeaterMeter board, I had a lot lot of trouble getting the solder to stick. I got better at it and the LCD board went together a lot better. I think it has to do with my...

I just built a new HeaterMeter with a Raspberry PI 3 and am using the snapshot from HeaterMeter Snapshots directory With just the HeaterMeter board attached to the RPI, I can get into the web interface but get the error below. Do I need to upgrade the AVR firmware or is something probably...

Over the weekend, I was searching for a BBQ thermometer that could be read from the internet for my BGE. I happened across the HeaterMeter and was very impressed with what I read. I ended up ordering the HeaterMeter V4.3 kit and a case from the HeaterMeter store. I am new to the Heatermeter...