Hi all-
Years ago I built a handful of Heatermeters (I wanted extra in case of issues - my original 4.2 is still working on my BBQ setup, though the LCD is starting to show its age and some wear issues after numerous years of use, which really don't matter much to me as I use wifi interface...
Only wireless probes I've seen are the Meater:
https://meater.com/
I invested in their kickstarter more than 2 years ago and I still haven't received my probes and block. I think wireless that can withstand cooking temps is much more difficult than they thought it would be. I'd stick with the...
I'm near the end of my smoke and I'm seeing probe reflections between probe ports:
The earlier part of this smoke session can also be seen in this thread...
Anyone have thoughts why my thermoworks probes seems to converge to nearly exact and matching value in minutes when they get near the 80 degree mark in the graphs below? I'm cooking a brisket and have a probe in the point and the flat. I think I've seen this on some past smokes as well.
If it happens again, see if you have your HM plugged into a AFCU or GFCU outlet. I was having lots of noise issues long ago and they were only showing up on my outdoor outlet which is one of those AFCU/GFCU outlets. Bryan made the 60Hz noise fix which helped solve most of my issues there.
You want it powered from the HM board. Powering from the Pi isn't enough to do everything you need in real use. Also, don't power both the HM and Pi at the same time. Read notes about that from this wiki page. Are you using a v4.2 HeaterMeter?
There is a basic troubleshooting page here if you...
While in another conversation I thought about this topic and decided to break it out into a new thread. Curious what everyone does for HM rain protection and possible options that might exist out there to spray/coat the electronics post-build. I'm seeing newer phones these days are coming with...
Quick and dirty option could be to just cover the button/lcd/led holes with solid (keeping case dimensions the same) and put up a couple of support pillars to hold things squeezed together where the LCD stack item would have been? I know I never use the buttons/lcd but I build my units with them...