Recent content by KevinE

Re-soldered all those points and blower is working awesome again! Thanks again for your help.

Thank you. This is very helpful.

First off, I want to thank Bryan for all this. I've built 3 HeaterMeters over the last several years but last week ended up buying a pre-soldered version (which is working awesome!!!). So, for my last 4.3 build, I noticed last week that the fan was not working as it should all the time...

Ok, got the pics working. Yes, I am using the rotodamper. I'll give those setting a shot and see how it goes. Thank you for the feedback.

Ok, let me see if I can get the pics working. Started fire with one single cotton ball soaked in 91% rubbing alcohol.

Did an overnight smoke of a butt...working out awesome. Once the temp settled in, everything has been working out great. With that said, when I first fire up, I overshoot the temperature by 50-60 degrees. I'm running a Vision Classic B with a new gasket and bottom vent sealed off. Below is my...

Did an overnight smoke of a butt...working out awesome. Once the temp settled in, everything has been working out great. With that said, when I first fire up, I overshoot the temperature by 50-60 degrees. I'm running a Vision Classic B with a new gasket and bottom vent sealed off. Below is my...

After some further thought on this, I do remember at one point when putting the new one in the case (while it was running), I did accidentally push down on the PI too much to where the USB housing touched the lcd and caused the lcd backlight to turn off (and then back on when I lifted it back...

A little backdrop. I built a 4.3 about a month ago and paired with a PI 3. Worked great on my first try (I have a failed 4.2 build in my past). Used it for a 3 or 4 cooks and worked fine with the exception that every now and again it would drop wifi. This weekend an build another 4.3 but with a...

Tried it with the beta and still no joy. Running Samsung S7 Edge. Tried uninstalling then reinstall, no dice. Cleared cache and data, nope. I didn't have this problem in my 4.2 version, so I think it must have something to do with the snapshot firmware. Just a guess.

But with the glue stick, how to you make sure there are no glue/brush marks on the finish (or remove them)?

I am running the release version of PitDroid (from the google play store). I am also running the snapshot firmware on the HM. Tried again last night and same issue.

I'd be curious if Tony has any tips as to technique as well. I have the same problem. Sticks well but you can see the glue marks on the finished product.

I too am having the authorization error even though I know I am putting in the password correctly.

So a quick update. For the D3 that was backwards, I ordered a new one two years ago but ended up going to radio shack and buying a replacement part. Still didn't work and when the new one came in the mail I just shoved it in a corner. This weekend, I took out he radio shack piece and put in the...