Wanting to add a webcam to the PI...... I believe I have everything except the kernel module kmod-video-uvc for kernel 4.9.58
The build instructions are very good, the underlying openwrt git no longer has the sources listed in the instructions........
Anyone by chance have the module already?
LEDE Reboot SNAPSHOT r5264-94491a1571 / LuCI Master (git-17.293.52428-5e28002)
Has the Services > uhttpd but does need the security settings to include the HM interface in a frame or an iframe on another domain.......
Good to go........ if I could keep my pit probe (thermocoupler) from pulling...
I think it is a browser cache issue on my end. The custom css was not showing the header background image.
css
#content {
/* Permalink - use to edit and share this gradient: http://colorzilla.com/gradient-edito...+89,990000+100 */
background: rgb(5,0,0); /* Old browsers */
background...
My HM has ran 24+ hours with 3 probes and a jumper wire in the pit no issues as well, I only had 1 food probe and no pit jumper when it locked up, I'll remove the jumper and 2 probes today.
Better logging would be nice but I find the logging mechanism to be severely lacking unless I cannot find...
I was hoping the better that my hardware had an issue.....
Side question, is the API write access broken in both of the downloadable img files on https://heatermeter.com/dl/ ?
Jerry
Setting temp does not work in LEDE Reboot SNAPSHOT r5264-94491a1571 / LuCI Master (git-17.293.52428-5e28002)
The API key is not set by PitDroid and there is no place to set it in PitDroid.....
Will this be updated at some point?
Jerry
Edit: it appears the API write is just broken by comments...
Hi Bryan,
I took the HM apart last night and re soldered everything (not something I wish on anyone) I also placed some butyl rubber spacers to stabilize the 3 boards in the HM and placed a small dab of hot glue on the connectors so there is no way the connections can move then put it in the...
I have had some issues with HM today. The 1st day of operation.
Hardware
Known good RPI 3b+
Known good sd card
Know good RF quality signal is great with 99% quality @72mbps, no dropped packets wile pinging
Power supply is 12v regulated 5 amp. the scope see little to no noise from the supply.
1...
Thanks Bryan,
Some way I must have damaged Q2. It has been replaced and the beeper now works, lucky I had one left from another PI project......
I Probably broke the gate internally during assembly just guessing......
Requires external oscillator per the datasheet. This one must be damaged or the driver is damaged.
If I look at the driver pins from the board with a scope, what should I see?
Jerry