Recent content by GeoffH

The graphs show the X and Y labels on CM 12? Interesting.. After looking at it closer.. it may be a resolution issue. So when I was using the app the other day with a cook. I had no labels, but opening it up now with out a connection. I see that there are labels but they are so small you...

Yes I installed it from there, but noted that there had not been any changes since 2013. I have a Nexus 6 running Android 5.1 and the graphs do not show correctly. They do not show the legend or X and Y labels. So I'm wondering if it is still being worked on or if it has been dropped by the...

Is this app still under develpment?

What size screws and nuts are these sized for? 256 ?

Still chugging along.. I'm calling it fixed and a new Heatermeter is born and healthy! Thanks guys! Will have to build one for my father now.

Its a little early to tell for sure, but I think the reflow of solder fixed it. Found two pins that did not have look to have enough solder on them. They were silver with solder but did not have the solder rising up the pin. It is running on the 2 amp power supply that previously over heated...

I'll reflow the solder joints tonight. Unlikely to be SD card related as I can edit config files via SSH. Also it never crashes unless the fan is running. I think the fan needs to be at 100% for it to crash. I suspect a bad solder joint in the power regulator circuit. I think under load it...

It's using the stock fan that came with the kit. Raspberry Pi model B. I don't think heat is the main issue anymore as when I tested it with a monitor this AM and it crashed, both boards were cold. But when I used the 2 amp wall wart and it crashed, both boards felt hot. Something is...

So I did some more testing. I hooked the pi up to a HDMI screen and found that it looks like it looses power. Screen goes black. I tried with a different Pi I have and got the same results.

So I built my HM last weekend. All went well, was very careful to use my cell phone to zoom in on all the components to identify them properly before soldering. Unit boots up and was able to connect to it and configure it for wifi with no problems. I have done two test cooks with it and the...