Recent content by B Frame

OK, so I am obviously not well versed in electronics. I purchased a servo that is designed to rotate 360 degrees, not 180 degrees. Once I replace it with the correct type of servo (9G SG90) everything worked just fine. Sorry for any confusion. It is great to have the whole thing working...

I have tried that several times. Unfortunately, the servo either does not move at all or spins continuously in one direction or the other. In the paragraph above the Setting the Servo Endpoints topic discusses the servo jumping all over the place and suggests it "can be solved by adding a...

I have a 4.3 HM with the Macro Damper using an SG90C servo. With the default settings of 1000us - 2000us, the servo runs continuously. I have tried various different settings in the Servo Pulse Duration with varying results. In all cases where there is any movement of the servo, it runs...

Got the button/display board built last night. I was able to add the pin header to the main board with no trouble. I did them after I had done all the soldering on the button/display board, so I was fairly comfortable with the soldering. After downloading the software twice to get the correct...

Have you had a chance to use it yet? If so, how did it work? Most importantly, what fan did you use? I am thinking of building one for my home built off-set smoker built from a 60 gallon propane tank. Thanks!

Thank you for the info. I have ordered the boards and the parts for the button/display board. I am a little concerned about building the board as the pin sockets were not installed on the board when it was built. It looks like it will be some tight work to add them after the fact, especially...

I was recently given an assembled HeaterMeter v4.3.3 board without either a Pi or the button/display board. Is it possible to obtain just the display board kit? if so, how much will it cost? And how do I order it? Thanks, Bill Frame