Bob Ivey
TVWBB Emerald Member
Interesting problem with my HM. I hooked it up at my desk to check a possible bad Maverick probe and I was able to log on to the HM with my password. That works fine so I know that I can communicate with it, but no probe temps are displayed and in the configuration, it is showing the probe 3 as disabled. When I enable probe 3, and try to enter a default for the probe coefficients, the drop down pops down and I select the et72 but nothing populates in the A, B, C locations. They are blank.
So to recap, I am communicating via wifi and am able to talk to the HM but nothing shows up on the home display. No temps at all. Everything, including the set temp is blank, and the probe 3 coefficients won't populate or communicate with the HM.
Any idea's?
So to recap, I am communicating via wifi and am able to talk to the HM but nothing shows up on the home display. No temps at all. Everything, including the set temp is blank, and the probe 3 coefficients won't populate or communicate with the HM.
Any idea's?