Eric Koenig
TVWBB Fan
After my last comp, I noticed that I severed the probe wire right where it meets the probe tip for my Guru Pitminder. I opened it up and, as I suspected, there are two very thin wires inside. I'm planning to reattach the wires, then seal this thing up.
I would usually use a shrink-wrap styled casing, but I'm sure that I can't do this here because it will later be subjected to high temps.
Any thoughts?
I would usually use a shrink-wrap styled casing, but I'm sure that I can't do this here because it will later be subjected to high temps.
Any thoughts?