Jason Medley
TVWBB Member
Hey Everyone,
Picked up my first Baby Q 100 used earlier this week. Saying it was well used and not cleaned up after each would be an understatement, but I got it in for a nice price, so can't complain...
Looking for some advice on some issues I have run into:
1) one touch ignition is working, but the burner is not igniting around the entire burner. I have tried to clean with a wire brush. It does not seem to be rusted through-just not sure why the gas is not making it around the full loop...
2) coating on the PCI grate has come off in areas. used some sos pads on the rust-but this thing probably needs replacing
3) No ash pan/plate-looks like about $9 for the plate and then $5 for a pack of small drip pans
I think I have seen the grates on eBay for ~$35.
I would like to resell this. Seems like they might sell for $50-80 used? Not a lot of room if I have to buy the parts!! What would you do?
Picked up my first Baby Q 100 used earlier this week. Saying it was well used and not cleaned up after each would be an understatement, but I got it in for a nice price, so can't complain...
Looking for some advice on some issues I have run into:
1) one touch ignition is working, but the burner is not igniting around the entire burner. I have tried to clean with a wire brush. It does not seem to be rusted through-just not sure why the gas is not making it around the full loop...
2) coating on the PCI grate has come off in areas. used some sos pads on the rust-but this thing probably needs replacing
3) No ash pan/plate-looks like about $9 for the plate and then $5 for a pack of small drip pans
I think I have seen the grates on eBay for ~$35.
I would like to resell this. Seems like they might sell for $50-80 used? Not a lot of room if I have to buy the parts!! What would you do?