Just starting a build and finding a pot here in the UK has been a challenge! Ended up with one from a local brew shop but it's a tiny bit too small on the base. It sits in place but can rock slightly or sit a little off centre leaving a gap of 1/8" or so on one side.
I'm keen to fix that before I go any further - presumably any gaps are undesirable and I want it to be stable enough not to worry about it.
Any ideas? My current thinking was nomex gasket around the pot to make it a touch wider just above the seat in the bowl but below the lip. I didn't really want to put tape on the bowl as I still want to grill on it (although my grate has a bit of slop too!).
I'll be sure to post a build thread once I get past this!
I'm keen to fix that before I go any further - presumably any gaps are undesirable and I want it to be stable enough not to worry about it.
Any ideas? My current thinking was nomex gasket around the pot to make it a touch wider just above the seat in the bowl but below the lip. I didn't really want to put tape on the bowl as I still want to grill on it (although my grate has a bit of slop too!).
I'll be sure to post a build thread once I get past this!