Is there a way to reset the atmega?

Bob Ivey

TVWBB Emerald Member

• Jun 8, 2016

• #1

I want to take one of my HM's (4.2.4) back to factory default. I seem to remember that a few years ago there was a way to basically default the ATMega chip. If memory serves right, there was a command you could use from the HM config page while inside the HM. Any thoughts would be appreciated.
TIA

 

Bob Ivey

TVWBB Emerald Member

• Jun 9, 2016

• #2

Can anyone help?????

 

Len Dennis

TVWBB Diamond Member

• Jun 9, 2016

• #3

Bob, I've got zero experience with heatermeters but:

will this help?

 

R

RalphTrimble

TVWBB Diamond Member

• Jun 9, 2016

• #4

Use the HM button to navigate the menu to RESET Config, if you have recent firmware it should reset the HM back to default.

 

Bob Ivey

TVWBB Emerald Member

• Jun 9, 2016

• #5

Len, already had that but as usual you are always there to help others. Thanks

Ralph, had already try that but your advice caused me to retry and with a few other steps got one of my HM's back working on my new network. Both wireless and wired are working on the same subnet. Go figure.

For now, all is well. Thanks for the help.