Problem with Blowers - Stoker II

Stoker had been working great for months. Purchased another WSM so needed another set of probes and blower. Tried hooking up the new setup in the middle of a cook (lesson learned) and now no blowers work. In the status field of the StrokerLog it shows "No (Fire) control Probes found". Any suggestions?

Thanks

I assume since you have the stoker II, you have the bigger power supply. I think it can run 2 10cfm fans

Plugging them in when it is on seems to provide horrible results at best

Personally, I would factory reset it, plug everything in and label it, then rename and reset everything and see if that works. I am not sure what type of circuitry protection it has, so I have no idea if you can hurt something by plugging it in while running

That may be a bug in stokerlog . Have not tested dual fire probes in a long time. When that happens, simply use the web interface and reassociate the fire probe.