Need some help setting up my Stoker II. I can see the Stoker on my network when connected by Ethernet (wired). Soon as I make entries into the website, disconnect the Ethernet and reboot I can no longer see on the network nor can I connect wirelessly. Here is what I have so far.
Wireless Network/Router assigned the IP Address of 192.168.1.3. I can input 192.168.1.3/wifi.html into my browser and get the expected screen (below).
I input my SSID, change Wifi Mode to “Access Point”, Select Security Mode as PSK (actual is WPAP2-Personal), enter my password. Click on “Save Changes” Disconnect the Ethernet, reboot and as stated above cannot connect to the device. Turn off the system, plug in the Ethernet cable, reboot the Stoker, and go to 192.168.1.3/wifi.html and I see the following data.
Current IP:192.168.100.1
Current subnet mask:255.255.255.0
Current gateway:
Wireless enabled
SSID: NETGEAR52
DHCP[I click this box but it comes back blank]
WiFi Mode:Client Access Point
Security Mode:None PSK
Passphrase: xxxxxxxxxxxx
IP address: 192.168.100.1
Subnet mask: 255.255.255.0
Gateway:
DNS server:
Changes will only be applied after reboot
I’m lost. I do know that the 192.168.100.1 is NOT the IP Address assigned to the Stoker nor is it the IP Address of my router. The router IP address is 192.168.1.1.
What am I doing wrong? Any assistance is greatly appreciated.
Wireless Network/Router assigned the IP Address of 192.168.1.3. I can input 192.168.1.3/wifi.html into my browser and get the expected screen (below).
I input my SSID, change Wifi Mode to “Access Point”, Select Security Mode as PSK (actual is WPAP2-Personal), enter my password. Click on “Save Changes” Disconnect the Ethernet, reboot and as stated above cannot connect to the device. Turn off the system, plug in the Ethernet cable, reboot the Stoker, and go to 192.168.1.3/wifi.html and I see the following data.
Current IP:192.168.100.1
Current subnet mask:255.255.255.0
Current gateway:
Wireless enabled
SSID: NETGEAR52
DHCP[I click this box but it comes back blank]
WiFi Mode:Client Access Point
Security Mode:None PSK
Passphrase: xxxxxxxxxxxx
IP address: 192.168.100.1
Subnet mask: 255.255.255.0
Gateway:
DNS server:
Changes will only be applied after reboot
I’m lost. I do know that the 192.168.100.1 is NOT the IP Address assigned to the Stoker nor is it the IP Address of my router. The router IP address is 192.168.1.1.
What am I doing wrong? Any assistance is greatly appreciated.