B Severson
New member
I have been running my HM 4 for a few years off of a old Linksys power supply. I am a little concerned (with the old HM dropping off the network) that the power supply has seen better days. I picked up a new P Supply at the surplus store and the tip is not a perfect match for the input on the HM. I have a HM 4.2 ready to go (with rotor damper). I found and old photo printer PS that has a 12volt DC output at 3amps. I think I read here that I could use more than 1.5amp just not less. Will this 3amp PS work???